Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com
3-10
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Chapter 3 Connecting the Cisco MDS 9200 Series
Connecting to a Fibre Channel Port
Note If you cannot install the cable into the transceiver, insert or leave the dust plug in the cable end
of the transceiver.
Removing an SFP Transceiver
To remove an SFP transceiver, follow these steps:
Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2 If a cable is installed in the transceiver:
a. Record the cable and port connections for later reference.
b. Press the release latch on the cable, grasp the connector near the connection point, and gently pull
the connector from the transceiver.
c. Insert a dust plug into the cable end of the transceiver.
Caution If the transceiver does not remove easily in the next step, push the transceiver completely in
and then ensure that the latch is in the correct position before continuing.
Step 3 Remove the transceiver from the port:
• If the transceiver has a Mylar tab latch, gently pull the tab straight out (do not twist), and then pull
the transceiver out of the port.
• If the transceiver has a bale clasp latch, open the clasp by pressing it downwards, and then pull the
transceiver out of the port.
Note If you have difficulty removing a bale clasp SFP transceiver, you should reseat the SFP by
returning the bale clasp in the up position. Then press the SFP inward and upward into the cage.
Next, lower the bale clasp and pull the SFP straight out with a slight upward lifting force (see
Figure 3-7). Be careful not to damage the port cage during this process.