Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com
2-29
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Chapter 2 Installing the Cisco MDS 9200 Series
Removing and Installing Components
Warning
Use of controls, adjustments, or performing procedures other than those specified may result in
hazardous radiation exposure.
Statement 1057
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
when servicing.
Statement 1034
Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by
the carrier edges only.
Note Install the Cisco MDS 9200 Series in the rack before installing modules. For information about installing
the chassis, see the “Installing the Chassis in a Cabinet or Rack” section on page 2-5.
This section includes the following topics:
• Removing a Caching Services Module, page 2-31
• Removing Other Switching or Services Modules, page 2-32
• Installing a Switching or Services Module, Including Caching Services Modules, page 2-33
• Verifying Installation of a Switching or Services Module, page 2-34
Figure 2-18 and Figure 2-19 show the positioning of a module in the chassis.