Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com
2-39
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Chapter 2 Installing the Cisco MDS 9200 Series
Removing and Installing Components
Figure 2-23 shows a fan module partially installed in the Cisco MDS 9200 Series.
Figure 2-23 Fan Module
Removing a Fan Module
Warning
When removing the fan tray, keep your hands and fingers away from the spinning fan blades. Let the
fan blades completely stop before you remove the fan tray.
Statement 258
To remove a fan module, follow these steps:
Step 1 Loosen the two captive screws on the fan module by turning them counterclockwise, using a flat-blade
or number 2 Phillips screwdriver if required.
Step 2 Grasp the fan module with both hands and pull it outward; rock it gently, if necessary, to unseat the power
connector from the backplane.
Step 3 Pull the fan module clear of the chassis.
Caution If the switch is powered on, you must hot-swap another fan module into this switch within five
minutes.
Installing a Fan Module
To install a fan module, follow these steps:
Step 1 Hold the fan module with the Fan Status LED at the top (see Figure 2-23).
Step 2 Place the fan module into the front chassis cavity so it rests on the chassis, lift the fan module up slightly
to align the top and bottom chassis guides, then push the fan module into the chassis until it seats in the
backplane and the captive screws make contact with the chassis, and tighten the captive screws.
LINK-
GE1
GE2
1
2
3
4
LINK-
1
0
1
1
1
2
1
3
1
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
6
122002
MDS 9216i