Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com
1-9
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Chapter 1 Product Overview
Integrated Supervisor Modules
LEDs on the Cisco MDS 9200 Series Integrated Supervisor Modules
Table 1-1 describes the LEDs for the Cisco MDS 9200 Series integrated supervisor modules.
Table 1-1 LEDs for the Cisco MDS 9200 Series Integrated Supervisor Modules
LED Status Description
Status Green All diagnostics pass. The module is operational (normal
initialization sequence).
Orange One of the following occurs or occurred:
• The module is booting or running diagnostics (normal
initialization sequence).
• The inlet air temperature of the system exceeded the
maximum system operating temperature limit (a minor
environmental warning). To ensure maximum product
life, you should immediately correct the
environmental temperature and restore the system to
normal operation.
Red One of the following occurred:
• The diagnostic test failed. The module is not
operational because a fault occurred during the
initialization sequence.
• The inlet air temperature of the system exceeded the
safe operating temperature limits of the card (a major
environmental warning). The card shut down to
prevent permanent damage. The system will be shut
down after two minutes if this condition is not cleared.
Speed
1
1. The Speed LEDs are available only on Cisco MDS 9216i and Cisco MDS 9216A Supervisor
Modules.
On 2-Gbps mode.
Off 1-Gbps mode.
Link Solid green Link is up.
Flashing
green
Link is up (beacon used to identify port).
Solid
yellow
Link is disabled by software.
Flashing
yellow
A fault condition exists.
Off No link.