Filter
Top Products
CHAPTER
Send documentation comments to mdsfeedback-doc@cisco.com
2-1
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
2
Installing the Cisco MDS 9200 Series
This chapter describes how to install the Cisco MDS 9200 Series and its components, and it includes the
following information:
• Preinstallation, page 2-2
• Installing the Chassis in a Cabinet or Rack, page 2-5
• Installing the Switch in a Cabinet with Insufficient Front Clearance, page 2-11
• System Grounding, page 2-19
• Grounding the Chassis, page 2-24
• Starting Up the Switch, page 2-26
• Removing and Installing Components, page 2-28
Note Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for the Cisco MDS 9000 Family for important safety information.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel must be allowed to install, replace, or service this equipment.
Statement 1030