Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com
3-12
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Chapter 3 Connecting the Cisco MDS 9200 Series
Connecting to a Fibre Channel Port
Figure 3-8 Connecting the LC-Type Cable to a Fibre Channel Port
Caution If the cable does not install easily, ensure that it is correctly oriented before continuing.
For instructions on verifying connectivity, see the Cisco MDS 9000 Family CLI Configuration Guide or
the Cisco MDS 9000 Family Fabric Manager Configuration Guide.
Removing a Cable from an SFP Transceiver
Caution When pulling a cable from a transceiver, grip the body of the connector. Do not pull on the jacket sleeve,
because this can compromise the fiber-optic termination in the connector.
Caution If the cable does not remove easily, ensure that any latch present on the cable has been released before
continuing.
To remove the cable, follow these steps:
Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2 Press the release latch on the cable, grasp the connector near the connection point, and gently pull the
connector from the transceiver.
Step 3 Insert a dust plug into the cable end of the transceiver.
Step 4 Insert a dust plug onto the end of the cable.
LC plug
SFP module
91681