Filter
Top Products
Send documentation comments to mdsfeedback-doc@cisco.com
Contents
iv
Cisco MDS 9200 Series Hardware Installation Guide
OL-17468-02
Installing a Cable into an SFP Transceiver 3-11
Removing a Cable from an SFP Transceiver 3-12
Maintaining SFP Transceivers and Fiber-Optic Cables 3-13
APPENDIX
A Cabinet and Rack Installation A-1
Cabinet and Rack Requirements A-1
General Requirements for Cabinets and Racks A-1
Requirements Specific to Perforated Cabinets A-2
Requirements Specific to Solid-Walled Cabinets A-3
Requirements Specific to Standard Open Racks A-3
Requirements Specific to telco Racks A-3
Cisco MDS 9000 Family telco and EIA Shelf Bracket A-4
Rack-Mounting Guidelines A-4
Before Installing the Shelf Brackets A-5
Required Equipment A-5
Installing the Shelf Bracket Kit into a Two-Post telco Rack A-6
Installing the Shelf Bracket Kit into a Four-Post EIA Rack A-7
Installing the Switch on the Shelf Brackets A-8
Removing the Shelf Bracket Kit (Optional) A-9
APPENDIX
B Technical Specifications B-1
Switch Specifications B-1
Module Specifications B-2
Weight of Modules B-3
Power Specifications B-4
Specifications for the Cisco MDS 9200 Series Power Supplies B-4
Component Power Requirements and Heat Dissipation Specifications B-5
X2 Transceiver Specifications B-7
Cisco 10-Gbps Fibre Channel X2 Transceivers B-7
General Specification for Cisco 10-Gbps Fibre Channel X2 Transceivers B-7
Environmental Conditions and Power Requirement Specifications for Cisco 10-Gbps Fibre
Channel X2 Transceivers
B-8
Cisco 10-Gbps Ethernet X2 Transceivers B-8
General Specification for Cisco 10-Gbps Ethernet X2 Transceivers B-9
Environmental and Power Requirements Specifications for Cisco 10-Gbps Ethernet X2
Transceiver
B-9
Cisco 10-Gbps Ethernet DWDM X2 Transceiver B-9
SFP and SFP+ Transceiver Specifications B-10
Cisco Fibre Channel SFP and SFP+ Transceivers B-10