Open as PDF
Installing System Components 119
Figure 3-21. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
Align the chassis intrusion switch with the securing bracket notch.
See Figure 3-21.
Slide the switch into the securing bracket notch. See Figure 3-21.
Connect the chassis intrusion switch cable to the connector on
the system board.
Close the system. See "Closing the System" on page 80.
Place the system upright on a flat surface.
Reattach any peripherals and connect the system to an electrical outlet.
Turn on the system and attached peripherals.
1 chassis intrusion switch 2 chassis intrusion switch cable
3 intrusion connector on the
book.book Page 119 Monday, August 9, 2010 3:07 PM