Open as PDF
Installing System Components 77
Installing the Front Bezel Insert
NOTE: If you remove a drive from one or more of the front drive bays, replace the
corresponding insert(s) on the front bezel.
From the back of the bezel, align the insert tab with the corresponding
notch on the bezel. Press the insert until the tab snaps into place.
See Figure 3-3.
Replace the front bezel. See "Installing the Front Bezel" on page 76.
EMI Filler Panel
Depending on the configuration of your system, an electromagnetic
interference (EMI) filler panel may be installed in one or more of
the 5.25-inch optical drive bays at the front of the system. EMI filler panels
are essential for airflow efficiency and for EMI protection. To install an
optical drive, the corresponding EMI filler panel must first be removed.
Removing an EMI Filler Panel
Remove the front bezel. See "Removing the Front Bezel" on page 75.
Remove the EMI filler panel out of the chassis by pulling firmly on the
holes in the middle of the filler panel. See Figure 3-4.
book.book Page 77 Monday, August 9, 2010 3:07 PM