Filter
Top Products
D-Link DHS-3224V Switch User’s Guide
4
Features
Ports
• One female RJ-21 port for connection to a VDSL splitter using Telco50 cabling.
• Uplink module with one 10/100 BASE-TX port for Ethernet over VDSL Uplink.
• 2 x IEEE1394 (Rx + Tx) “FireWire” ports for Switch-to-Switch operations.
• One female RS-232 DCE diagnostic port (console port) for setting up and managing the Switch via a
connection to a console terminal or PC using a terminal emulation program.
Performance Features
• Quadrature Amplitude Modulation (QAM)
• Frequency Division Duplexing
• Spectral compatibility with xDSL, ISDN (2B1Q/4B3T), digital PBX extensions and narrow band
interference
• 8.8 Gbps switching fabric capacity
• Store and forward switching scheme.
• 8K active MAC address entry table per device with automatic learning and aging (10 to 1000000
seconds).
• 8 MB packet buffer per device.
• 802.1D Spanning Tree support.
• 802.1Q Tagged VLAN support
• Supports up to 24 end users per Switch (24 ports)
• Up to 6 Switches can be stacked in a 19” equipment rack and managed as a unit
Management
• Provisioning for VDSL Settings (per Port)
• RS-232 console port for out-of-band network management via a console terminal.
• Spanning Tree Algorithm Protocol for creation of alternative backup paths and prevention of network
loops.
• SNMP v.1 Agent.
• Fully configurable either in-band or out-of-band control via SNMP based software.
• Flash memory for software upgrades. This can be done in-band via TFTP.
• Built-in SNMP management:
- Bridge MIB (RFC 1493)
- MIB-II (RFC 1213)
- Mini-RMON MIB (RFC 1757) – 4 groups
- 802.1p MIB (RFC 2674).
• TFTP support
• BOOTP support
• DHCP Client support
• Password enabled.
• Telnet remote control console
• Web Management Software