Filter
Top Products
D-Link DHS-3224V Switch User’s Guide
17
Install the Ground Wire on the DSL Splitter
The DSL Splitter chassis must be properly grounded. A ground connection for this purpose is located on the
front panel of the Splitter (near the D-LINK logo). Use 10 – 12 gauge (or heavier) copper wire for grounding the
Splitter. Attach the ground wire securely to a suitable grounding post. See Figure 4-7 below.
Figure 4-6. Ground Wire for DSL Splitter
Connection to End User
The separate signals for both VDSL and POTS service are carried to subscribers via standard 0.4mm or 0.5mm
twisted-pair telephone cabling. Connection to the CPE is made with standard RJ-11 connectors that are familiar
to the subscriber. The CPE device is a simple bridge and does not require that any driver or software be installed
by the subscriber. Therefore, remote installation of CPE should not be difficult.
When the Ethernet over VDSL System has been connected, service must be enabled for each connected port. It
may also be necessary to change the connection speed for the individual ports. Ports on the Switch are enabled
and configured using the Configure Ports option of the console manager. See the Configure Ports section in
Chapter 6 for information on enabling port and controlling port bit rates.