112
Loading non-standard sized film
Follow these steps to load non-standard sized film:
1. Place the film directly on the
document table making sure
the glossy (smooth) side of the
film faces down.
If the reflective document mat
is installed in the transparency
unit, remove it.
2. Close the TPU and begin your
scan.
If you’re using EPSON TWAIN Pro to scan, set the focus position
to 0.0.
An area 2±1.5 mm from the horizontal and vertical edges of
the document table glass will not be scanned.
The scanner will generate an error message if the calibration
area is blocked. Also, dirt or dust on the calibration area can
result in vertical lines being added to the image. Keep the
calibration area clear and clean.
Scanning Reflective Documents
To scan reflective documents with the transparency unit installed, insert the reflective
document mat included with the transparency unit.
1. Open the transparency unit. If there’s a film guide or transparency unit on the
document table, remove it.
2. Slide the mat into place and
insert the tabs into the slots on
the transparency unit.
calibration area