Filter
Top Products
CHAPTER 6 Work after installation
6.1 Redundant configuration of network adaptor
94
Work after installation CHAPTER 6
This chapter explains the operation which is to be implemented after introducing the PRIMEQUEST 2000 series, such as
setting of NTP or setting of security.
6.1 Redundant configuration of network adaptor
For establishing the network after installation, following teaming (multi-pass) is set by using the utility corresponding to each
network adaptor.
Setup of network adaptor (Intel Gigabit Ethernet (GbE))
For management LAN and operation LAN, redundant setting of network is done. Network to be targeted is (2) in the
following Figure.
- Windows: Configure the teaming by using the Intel PROSet (R) (*1). For details, see help of IntelPROSet (R).
*1: In Windows Server 2012 or later, NIC teaming of standard function of the operating system, can also be used.
FIGURE 6.1 External network configuration
Number
Description
(1)
Switching Hub redundancy
(2)
redundancy by teaming(such as GLS)
(3)
Standby side is disabled
Note
There are some notes on teaming with IntelPROSet (R).
For the details on the notes, see “G.9 NIC (Network Interface Code)” of PRIIMEQUEST 2000 Series Administration
Manual (C122-E175EN)