Fujitsu 2000 Server User Manual


 
CHAPTER 3 Work before Operating System Installation
3.3 Connection and Setting of MMB
14
FIGURE 3.3 Network Configuration and IP Address of Management LAN
Ports for managing MMB#0 and MMB#1 are connected to the external switching hub device using a LAN cable. At the
same time MMB console PC is also connected to the external switching hub device. Physical IP address and Virtual IP
address of MMB#0 and MMB#1 are set in identical subnet.
- Physical IP Address (In the above figure, MMB#0=192.168.1.100, MMB#1=192.168.1.101)
- Virtual IP Address (In the above figure, 192.168.1.102)
For external connection (Web browser, Terminal for Maintenance, REMCS, etc.), communication is done by virtual IP
address.
TABLE 3.4 Settings required for connecting external LAN
Conditions
Required settings
When using the switching hub which supports the
circulatory prevention function (Spanning Tree
Protocol or the domain Separation, etc.) in the
external switch
Prevent circulatory prevention function to [disable] Spanning Tree Protocol
of connection port of switching hub and the main unit or to set Domain
Separation ‘ON’.
When the data given below corresponds to any of
the category-
-Destination server becomes external server which
is passed through the firewall.
-Use a mail server which restricts the IP address.
It is necessary to set the firewall and mail server in such a way that
physical IP address packets of MMB #0 and MMB#1 can pass through.
For REMCS connection
Connection format is as given below.
- When connecting to internet:
Connect REMCS port to the external switching hub. Or connect to the
center by restricting the firewall
from the external switch of the
management port.
- When connecting to P-P
Connect each REMCS port of MMB of MMB#0 and MMB#1 to the Dial-
up route directly.
For details on REMCS linkage, see PRIMEQUEST 2000 series REMCS
Service Installation Manual (C122-E180EN).
Remark
- Packets are transmitted from MMB in “NTP”, “Alarm E-Mail”, and “REMCS”. When both the physical IP address and
the virtual IP address of MMB are set, the transmission source IP address of packet is considered as the physical IP
address of the MMB.