Filter
Top Products
CHAPTER 4 Installation of Operating System and bundled software
4.5 Procedure to install RHEL into internal HDD/SSD
59
Note:
It can be started by selecting "Force boot from DVD" by Boot Selector or it can be started from the virtual media by
changing the boot order to DVD by UEFI.
When operating system corresponds to the UEFI mode, the installation can be done in UEFI mode by changing the
boot order according to the following procedure.
a. After turning on the power supply of the partition, while the FUJITSU logo is displayed, press any key (such as
[Space] key) except [Enter] key and the Boot Manager front page is displayed.
b. The menu is selected on the Boot Manager front page in the following order. [Boot Maintenance Manager]-
[Boot Options]-[Change Boot Order]-[Change the order]
c. UEFI:Fujitsu Virtual CDROMx xxx is set on the top step.
For details on the setting method of boot order, see “■ Change Boot Order of “3.5.2 [Boot Options] menu” of
PRIMEQUEST 2000 series Tool Reference (C122-E177EN).
d. [Commit Changes and Exit] - [Reset System] is specified and the partition is rebooted.
3. After a period of time, the language selection window is displayed.
In case of English, select “English”.
4. In initial display window, click [Next] button without setting anything.
5. Select [Deployment] in [Welcome ServerView Installation Manager] window.
6. Select installation mode, select operating system to be installed and set the operating system.
Remark
The IP address of LAN cannot be set in setting operating system. Set IP address after installing the operation system.
7. Click [Start installation].
The installation is started.
8. Replace with the installation medium of operating system according to the instructions of SVIM.
4.5.4 Configuring Bundled Software after Installation
Bundled software is configured after installing the operating system.
1. The trap destination from the partition is configured.
Remark
Configuring of the trap destination can be checked by using standard trap for SNMP service. For details, see “6.5.2
Configuring SNMP”.
2. The trap destination and Mail destination through MMB are configured.
In linkage with operations management software, it is configured only if necessary.
- Configuring SNMP trap destination through MMB
See “6.5.2 Set up of SNMP”
- The report destination and the filter are set when Alarm E-Mail is configured.
See “3.3.9 Set up of Alarm E-Mail”
3. OneCommand Manager is installed while installing FC card.
a. By executing the following command, the libnl package information is displayed. Confirm that libnl is installed.
# rpm -qi libnl
If libnl is not installed, search libnl package in installation media of distribution, and install libnl package by
executing the following command.
# rpm -ivh libnl-<version>-<release>.<arch>.rpm
Remark
Read the part of <version>, <release>, <arch> properly.
b. Download the driver/utility of MC-0JFC31/31B/41/41B/91/91B/A1/A1B from the following URL.