Filter
Top Products
CHAPTER 4 Installation of Operating System and bundled software
4.2 Procedure to install Windows in SAN/iSCSI storage device
48
ROM”.
- For the UEFI Install:
- Set [Device Manager]-[PCI Subsystem Configuration]-[PCI ROM Priority] of BIOS menu to ”Legacy ROM”.
- Set [Device Manager]-[PCI Subsystem Configuration]-[OpROM Scan Configuration] of BIOS menu to “Enable”
only for booting Device.
3. BIOS is set to recognize LUN of FC card.
For the settings of FC card, Converged Network Adapter and NIC for iSCSI Boot, see PRIMEQUEST 1000/2000
Series SAN Boot Environment Configuration Manual (C122-E155) .
4. The partition settings in MMB are confirmed after the internal HDD/SDD of PRIMEQUEST is removed.
- SB/IOU configuration is set
See “3.4.1 Setting the partition configuration”
- Console redirection is set
See “3.4.6 Settings of Console Redirection”
- Video redirection: Enable
- Virtual media: Enable
- Various modes are set
See “3.4.5 Various mode settings”
5. Only LUN which becomes the installation target of SAN storage device is connected to the partition of
PRIMEQUEST.
For the settings of SAN storage device, see “Attached manual in the SAN storage device”.
6. I/O space is allocated in FC card of the boot path target and SAS RAID controller, RAID card. For the allocation of I/O
space, see “5.5.1 How to use sadump (Linux)” and “3.4.5 Various mode settings” of PRIMEQUEST 2000 series
Administration Tool Reference (C122-E177EN).
4.2.2 Preparation for installation
The following preparations are done.
1. The following disk images should be prepared.
Media of Windows operating system
2. FC cable is made a single path (Connection of only 1 FC cable).
4.2.3 Installation of operating system
Operating system installation by SVIM is explained.
There are the following types in the operating system installation by SVIM. For the detailed procedure of the respective
modes, see ServerView Suite ServerView Installation Manager.
TABLE 4.1 Operating system installation by SVIM
Mode
Function Overview
Objective
Quick
Mode
The operating system can be installed in the state recommended by
Fujitsu by only executing the required minimum settings.
This mode is used when
operating system is easily
installed.
Guide
Mode
It is set according to wizard set up information. The information that was
set, is saved in a configuration file and can be used at the time of re-
install
This mode is used for
advanced setting of RAID and
operating system.
All the inserted windows are examples of display and the contents displayed by the system configuration, etc. are different.
Operations
1. Make the settings by which the ServerView Suite DVD is booted from the virtual media for the partition.
For settings, see“1.6.2 Remote control operation (BMC)” of PRIMEQUEST 2000 series Administration Manual
(C122-E175EN).