Filter
Top Products
CHAPTER 4 Installation of Operating System and bundled software
4.5 Procedure to install RHEL into internal HDD/SSD
57
c. The file to be downloaded is copied in an arbitrary directory of the PRIMEQUEST 2000 series and then
extracted.
# tar xvzf F1010350.tar.gz
d. The file given below is extracted.
Remark
For the method of installing “SNIA HBA API library”, see readme.txt extracted under HBA_API_LIB.
e. Reboot the partition after installation.
FIGURE 4.1 File Structure
4. The dump area is configured.
Confirm that hard disk
has enough free space before collecting the memory dump.
5. Save the management information and configuration.
For details, see “5.7 Saving management and configuration information”.
6. RAS support service is configured.
For details, see “5.8 Setup for lifespan monitoring according to RAS support service”.
When the life of UPS battery is to be monitored, see “5.8.1 Monitoring life-span of UPS battery”.
7. Watchdog Timer allows reboot OS in case that OS freezes.
Rebooting OS is executed when the set time
passes.
For details, see “8.4 Automatic Partition Restart Conditions” of PRIMEQUEST 2000 series Administration
Manual (C122-E175EN).
4.4.5 After installation, connecting SAN and internal HDD/SSD
See PRIMEQUEST 1000/2000 Series SAN Boot Environment Configuration Manual (C122-E155), for connecting SAN
with internal HDD/SSD, after installation.
Moreover, for details on driver parameter, see readme of the driver supplied.
4.5 Procedure to install RHEL into internal HDD/SSD
This section briefly describes the procedure to install RHEL into internal HDD/SSD.
Start the installation after confirming the MMB configuration and successful to log in to the MMB.
4.5.1 Presetting
If necessary, the following settings are done.
1. Remove each internal HDD that is not the installation destination.
2. The setting of partition is checked by MMB.
- Setting of configuration of SB/IOU
See “3.4.1 Setting the partition configuration”
- Setting of Console Redirection
See “3.4.6 Settings of Console Redirection”
- Video redirection: Enable
- Virtual media: Enable
- Setting of various modes