Filter
Top Products
CHAPTER 5 Work after Operating System installation
5.1 Types of work
72
Work after Operating System CHAPTER 5
installation
This chapter describes every setting that is required after the installation of the operating system of the PRIMEQUEST
2000 Series
5.1 Types of work
Content and type of operations that are to be implemented after installation of the operating system are given below.
TABLE 5.1 Type of operations
Task
Description
Installed operating
system
See
Setting of SVAgent
Setting of SVAgent
Linux, Windows
5.2 Setting of SVS
(SVagent/SVmco)
Setting of sadump
Setting of sadump
Linux
5.3 Setting of sadump
Setting of Dump environment
Setting of Dump environment
Windows
5.4 Setup of dump
environment (Windows)
Setting of Dump environment
Setting of Dump environment
Linux
5.5 Setup of dump
environment (Linux)
Setting of NTP client
Setting of NTP client
Linux
5.6 Setup of NTP client
Information management/Save
configuration information
Management information of
MMB / Save configuration
information of BIOS
Linux, Windows
“5.7 Saving management and
configuration information
Life monitoring setting according
to RAS backup service
Life monitoring setting of FBU
and UPS battery
Linux, Windows
5.8 Setup for lifespan
monitoring according to RAS
support service
5.2 Setting of SVS (SVagent/SVmco)
Settings for following products must be done after installation of OS. See the following manuals for the details of the
settings of SVagent/SVmco.
SVmco is necessary, only when you use PRIMECLUSTER linkage
- SVagent:
ServerView Operations Manager Installation ServerView Agents for Linux
ServerView Operations Manager Installation ServerView Agents for Windows
- SVmco:
ServerView Mission Critical Option User Manual.
5.3 Setting of sadump
In sadump, the following items are set for each partition.
- Validation of sadump
- Collection address of dump
- Compression at the time of dump collection
- Movement after dump collection
- Re-use of dump collection address.