Filter
Top Products
109
CHAPTER 2 DEPENDENCE FUNCTIONS
(4) Set trace-buffer-full break.
The program can be allowed to break when the trace buffer becomes full. Use the SET TRACE command
for this setting. The default is Not Break. Display the setup status using the SHOW TRACE/STATUS
command.
Table 2.2-10 lists trace-related commands that can be used in the single trace function.
Table 2.2-10 Trace-related Commands That Can Be Used in The Single Trace Function
Usable Command Function
SET EVENT
SHOW EVENT
CANCEL EVENT
ENABLE EVENT
DISABLE EVENT
Sets events
Displays event setup status
Deletes event
Enables event
Disables event
SET SEQUENCE
SHOW SEQUENCE
CANCEL SEQUENCE
ENABLE SEQUENCE
DISABLE SEQUENCE
Sets sequencer.
Displays sequencer setting status
Cancels sequencer
Enables sequencer
Disables sequencer
SET DELAY
SHOW DELAY
Sets delay count value, and operation after delay
Displays delay count setting status
SET TRACE
SHOW TRACE
SEARCH TRACE
ENABLE TRACE
DISABLE TRACE
CLEAR TRACE
Sets trace-buffer-full break
Displays trace data
Searches trace data
Enables trace function
Disables trace function
Clears trace data