Filter
Top Products
206
CHAPTER 2 DEPENDENCE FUNCTIONS
2.4.1.3 Debug Area
Set the intensive debugging area out of the whole memory space. The area functions are
enhanced.
■ Setting Debug Area
There are two debug areas: DEBUG3, and DEBUG4. A continuous 1 MB area (16 banks) is set for each area.
Set the debug area using the SET DEBUG command.
Setting the debug area enhances the breakpoint function.
- Enhancement of Breakpoints
Up to six breakpoints (not including temporary breakpoints set using GO command) can be set when the
debug area has not yet been set.
When setting the debug area as the CODE attribute, up to 65535 breakpoints can be set if they are within
the area. At this time, up to six breakpoints can be set for an area other than the debug area, but the total
count of breakpoints must not exceed 65535. In 00 to 0F bank and 0F0 to 0FF bank, a breakpoint can be
set without specifying the debug area. (DEBUG1, DEBUG2)