Filter
Top Products
83
CHAPTER 2 DEPENDENCE FUNCTIONS
2.2.5.3 Sequential Break
A sequential break is a function to abort a executing program, when the sequential
condition is met by event sequential control.
■ Sequential Break
It is a function to discontinue the program execution when the sequential condition consists by the sequential
control of the event. Use a sequential break when the event mode is set to normal mode using the SET
MODE command.
When a break occurs due to a sequential break, the following message is displayed on the Status Bar.
Break at Address by sequential break (level = Level No.)
For details of the sequential break function, refer to Section "2.2.7 Control by Sequencer".
■ Setting Method
The sequential break is controlled by the following method.
1. Set event mode (SET MODE)
2. Set events (SET EVENT)
3. Set sequencer (SET SEQUENCE)