Filter
Top Products
74
CHAPTER 2 DEPENDENCE FUNCTIONS
2.2.2 Notes on Commands for Executing Program
When using commands to execute a program, there are several points to note.
■ Notes on GO Command
For the GO command, two breakpoints that are valid only while executing commands can be set. However, it
is required to be careful in setting these breakpoints.
- Invalid Breakpoints
No break occurs when a breakpoint is set at the instruction immediately after the following instructions.
- No break occurs when breakpoint set at address other than starting address of instruction.
- No break occurs when both following conditions met at one time.
- Instruction for which breakpoint set starts from odd-address,
- Preceding instruction longer than 2 bytes length, and breakpoint already set at last 1-byte address of
preceding instruction (This "already-set" breakpoint is an invalid breakpoint that won't break, because
it has been set at an address other than the starting address of an instruction).
F
2
MC-16L/16LX/16/16H
PCB
NCC
SPB
MOV ILM,#imm8
OR CCR,#imm8
DTB
ADB
CNR
AND CCR,#imm8
POPW PS
F
2
MC-16F
PCB
NCC
SPB
DTB
ADB
CNR