Filter
Top Products
285
CHAPTER 2 DEPENDENCE FUNCTIONS
2.6.4.3 Power-on Debug
This section describes power-on debug function in the MB2100-01 emulator debugger.
■ Power-on Debug
Power-on debug is a function to debug the sequence immediately after turning on of the power supply of the
target system.
■ How to use
The use procedure of power-on debug is as follows:
● When power-on debug
1. Start debug.
Select [Debug] - [Start debug] menu.
2. Power-on debug mode is made effective.
Select [Debug] - [Run] - [Power on Debug] menu.
It shifts to power-on debug mode.
3. Execute the user program.
Continuous execution of the user program that doesn't do anything such as infinity looping is recommended.
Display the confirmation dialog whether the program execution is interrupted.
4. Do either the following:
• Chip reset is issued from the outside.
• The power supply of the target is turned on again.
After the power supply returns, the program starts running from the reset vector.
● When release power-on debug mode
Before executing the user program
Select [Debug] - [Run] - [Power on Debug] menu.
After executing the user program
Press the cancel button by the interruption dialog displayed in power-on debug mode.