Filter
Top Products
80 SPARC Enterprise T5440 Server Service Manual • June 2011
4. Close the latch to lock the drive in place.
5. At the Solaris prompt, type the cfgadm -al command to list all drives in the
device tree, including any drives that are not configured. Type:
This command should help you identify the Ap_id for the hard drive you
installed. For an output example refer to EXAMPLE: Sample Ap_id Output on
page 81.
6. Type the cfgadm -c configure command to configure the disk.
For example, type:
where c0::sd1 is the disk that you are trying to configure.
7. Wait until the blue Ready-to-Remove LED is no longer lit on the drive that you
installed.
8. At the Solaris prompt, type the cfgadm -al command to list all drives in the
device tree, including any drives that are not configured. Type:
This command should identify the Ap_id for the hard drive that you installed.
The drive you installed should be is configured.
# cfgadm -al
# cfgadm -c configure c0::sd1
# cfgadm -al