Filter
Top Products
Servicing Field-Replaceable Units 151
■ “Remove the Server From the Rack” on page 71
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 73
■ “Remove the Top Cover” on page 73
■ “Remove a Fan Tray” on page 87
■ “Remove the Fan Tray Carriage” on page 133
1. Unplug the front control panel cable from J9901 on the motherboard.
2. Unplug the front control panel cable from the front I/O board.
3. Remove the two No. 2 Phillips screws.
4. Lift the front I/O board up and out of the system.
5. Place the front I/O board on an antistatic mat.
▼ Install the Front I/O Board
1. Lower the front I/O board into the system.
2. Install the two No. 2 Phillips screws.
3. Plug the front control panel connector into the front I/O board.
4. Plug the front control panel connector into J9901 on the motherboard.