Filter
Top Products
62 SPARC Enterprise T5440 Server Service Manual • June 2011
The following table shows typical combinations of ALOM CMT variables and
associated POST modes.
Related Information
■ “Diagnostic Flowchart” on page 13
■ “Detecting Faults Using LEDs” on page 34
■ “ILOM-to-ALOM CMT Command Reference” on page 58
■ SPARC Enterprise T5440 Server Administration Guide
■ Integrated Lights Out Manager 3.0 Supplement for the SPARC Enterprise T5440 Server
show /SYS/LOCATE showlocator Displays the current state of the
Locator LED as either on or off.
show /SP/logs/event/list showlogs [-b lines | -e lines |
-v] [-g lines] [-p
logtype[r|p]]]
Displays the history of all events
logged in the service processor
event buffers (in RAM or the
persistent buffers).
show /SYS showplatform [-v] Displays information about the
operating state of the host system,
the system serial number, and
whether the hardware is providing
service.
Parameter
Normal Diagnostic Mode
(Default Settings) No POST Execution
Diagnostic Service
Mode
Keyswitch Diagnostic
Preset Values
diag mode normal Off service normal
keyswitch_state normal normal normal diag
diag_level max N/a max max
diag_trigger power-on-reset
error-reset
None all-resets all-resets
diag_verbosity normal N/a max max
Description of POST
execution
This is the default POST
configuration. This
configuration tests the
system thoroughly, and
suppresses some of the
detailed POST output.
POST does not
run, resulting in
quick system
initialization. This
is not a suggested
configuration.
POST runs the full
spectrum of tests
with the maximum
output displayed.
POST runs the full
spectrum of tests
with the maximum
output displayed.
ILOM Command ALOM CMT Command Description