Filter
Top Products
Managing Faults 61
set /SYS/keyswitch_state
value
normal | stby | diag |
locked
setkeyswitch [-y] value
normal | stby | diag | locked
• -y enables you to skip the
confirmation question when
setting the keyswitch to stby.
Sets the virtual keyswitch.
set /SUS/LOCATE value=value
[Fast_blink | Off]
setlocator value
[on | off]
Turns the Locator LED on the server
on or off.
(No ILOM equivalent.) showenvironment Displays the environmental status
of the host server. This information
includes system temperatures,
power supply, front panel LED,
hard drive, fan, voltage, and current
sensor status. See “Display
Individual Component Information
(ILOM show Command)” on
page 28.
show faulty showfaults [-v] Displays current system faults. See
“Detecting Faults” on page 34.
(No ILOM equivalent.) showfru [-g lines] [-s | -d] [FRU]
• -g lines specifies the number of
lines to display before pausing
the output to the screen.
• -s displays static information
about system FRUs (defaults to
all FRUs, unless one is specified).
• -d displays dynamic information
about system FRUs (defaults to
all FRUs, unless one is specified).
See “Display Individual
Component Information (ILOM
show Command)” on page 28.
Displays information about the
FRUs in the server.
show /SYS/keyswitch_state showkeyswitch Displays the status of the virtual
keyswitch.
ILOM Command ALOM CMT Command Description