Filter
Top Products
Managing Faults 25
Note – You can use the FB-DIMM DIAG buttons on the CMP module and memory
module to identify faulty FB-DIMMs. See “FB-DIMM Fault Button Locations” on
page 117.
Once you identify which FB-DIMMs you want to replace, see “Servicing FB-DIMMs”
on page 108 for FB-DIMM removal and replacement instructions. You must perform
the instructions in that section to clear the faults and enable the replaced FB-DIMMs.
Related Information
■ “POST Parameters” on page 30
■ “Displaying FRU Information With ILOM” on page 27
■ “Detecting Faults” on page 34
■ “Servicing FB-DIMMs” on page 108
Connecting to the Service Processor
Before you can run ILOM commands, you must connect to the service processor.
There are several ways to connect to the service processor.
Related Information
■ “Diagnostic Flowchart” on page 13
Topic Links
Connect an ASCII terminal directly to the
serial management port.
SPARC Enterprise T5440 Server Installation
and Setup Guide
Use the ssh command to connect to service
processor through an Ethernet connection
on the network management port.
SPARC Enterprise T5440 Server Installation
and Setup Guide
Switch from the system console to the
service processor
“Switch From the System Console to the
Service Processor (ILOM or ALOM CMT
Compatibility Shell)” on page 26
Switch from the service processor to the
system console
“Switch From ILOM to the System Console”
on page 26
“Switch From the ALOM CMT
Compatibility Shell to the System Console”
on page 26