Filter
Top Products
Servicing Field-Replaceable Units 129
● Plug the IDPROM into its connector on the service processor.
Ensure that the service processor is oriented correctly. A notch on the IDPROM
corresponds to a similar notch on the connector.
Servicing the Battery
The battery provides the power necessary to maintain system configuration
parameters during power outages, or while the system is being serviced, stored or
relocated.
■ “Remove the Battery” on page 129
■ “Install the Battery” on page 130
Related Information
■ “Servicing the Service Processor” on page 124
■ “Servicing the IDPROM” on page 127
▼ Remove the Battery
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 63.
■ Power off the server, using one of the methods described in the section, “Powering
Off the System” on page 67.
■ “Extend the Server to the Maintenance Position” on page 70
■ “Disconnect Power Cords From the Server” on page 68
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 73
■ “Remove the Top Cover” on page 73
■ “Remove the Service Processor” on page 124
1. Release the latch securing the battery to its holder on the service processor
board.
2. Lift the battery up and off the board.