Fujitsu T5440 Server User Manual


 
Managing Faults 57
Note – A reset or power cycle is required after disabling or enabling a component. If
the status of a component is changed, there is no effect to the system until the next
reset or power cycle.
Related Information
“Diagnostic Flowchart” on page 13
“Detecting Faults” on page 34
SPARC Enterprise T5440 Server Administration Guide
Disable System Components
The component_state property disables a component by adding it to the ASR
blacklist.
1. At the -> prompt, set the component_state property to Disabled:
2. Reset the server so that the ASR command takes effect.
Note – In the ILOM shell there is no notification when the system is actually
powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.
Re-Enable System Components
The component_state property enables a component by removing it from the ASR
blacklist.
-> set /SYS/MB/CPU0/CMP0/BR1/CH0/D0 component_state=Disabled
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS