Filter
Top Products
GEK-00029B 5000 Series Programmer’s Manual
109
CR Carriage Return:
CR moves the current print position to the left
margin. If auto LF on CR is set, either by Emulation Settings menu
option or by command (ESC 5), then a line feed will also be executed.
Decimal: 13
Hex: 0D
BASIC: CHR$(13);
DC1 Device Code 1:
Select printer (parallel interface only). DC1 sets the
printer online after being deselected by an ESC Q.
Decimal: 17
Hex: 11
BASIC: CHR$(17);
DC2 Device Code 2:
Sets 10 cpi printing. DC2 sets the printer to 10 cpi (5
cpi if double-wide is enabled). It cancels condensed printing mode
and 12 cpi printing.
Decimal: 18
Hex: 12
BASIC: CHR$(18);
DC3 Device Code 3:
Deselect printer. When using a serial interface, DC3
(XOFF) is sent to the host to indicate the printer is not ready to
accept data. When using a parallel interface, a received DC3 is
treated as a NUL.
Decimal: 19
Hex: 13
BASIC: CHR$(19);
DC4 Device Code 4:
Cancel double-wide printing by line. DC4 cancels
one-line double-wide print set by an SO code. It does not cancel
continuous double-wide printing set by ESC W 1.
Decimal: 20
Hex: 14
BASIC: CHR$(20);
ESC Escape:
Introduces an escape sequence. ESC tells the printer that
the following characters are to be interpreted as a printer command,
not printable data. See the section on Proprinter escape sequences.
Decimal: 27
Hex: 1B
BASIC: CHR$(27);
FF Form Feed:
Advances the paper to the next top of form with the print
position at the left. If a top margin is set, paper advances to the first
print line below the margin.
Decimal: 12
Hex: 0C
BASIC: CHR$(12);