Filter
Top Products
GEK-00029B 5000 Series Programmer’s Manual
237
PUM Positioning Unit Mode:
Establishes the unit for the numeric
parameters of certain control functions.
Source:
Application
Destination:
Level 3
Format
CSI 1 1 h Sets PUM.
CSI 1 1 1 Resets PUM.
Description
When PUM is set, the setting of Select Size Unit (SSU) determines
unit size: decipoint, centipoint, or pixels. When PUM is reset, unit
size is defined as columns in horizontal spacing commands and lines
in vertical spacing commands. Actual column widths and line heights
are set by control functions or are taken from the currently selected
font.
The Positioning Unit Mode (PUM) establishes the unit for the numeric
parameters of the following sequences:
▪
HPA, HPB, HPR
▪
VPA, VPB, CUU
▪
VPR, DECSHTS, DECSVTS
▪
DECSLPP, DECSTBM, DECSLRM
RIS Reset to Initial State:
Resets printer state variables to their initial
values. RIS has the same effect as Soft Terminal Reset (DECSTR).
Source:
Print manager
Destination:
Levels 1, 2, 3
Format
ESC c 1/11 6/3
Description
See the DECSTR command for details.
Notes to Software
This command is included for backwards compatibility with older
printers only. Conforming software should not use this command.
ESC c is reserved for other uses in some protocols.