Filter
Top Products
GEK-00029A 5000 Series Programmer’s Manual
175
GSM Graphic Size Modification:
This sequence will change the height
and/or width of graphic characters. The first and second parameters
are the percentages by which the height and width respectively will
be multiplied. The default value for both p1 and p2 is 100 percent.
General Command Syntax
ESC [
Pn1;Pn2
SP B
Decimal: 27 91
Pn1
59
Pn2
32 50
Hex : 1B 5B
Pn1
3B
Pn2
20 42
BASIC: CHR$(27);”[“;
Pn1
;”;”;
Pn2
;” B”;
GSS Graphic Size Selection:
Sets the height and width of all characters
that start after the control sequence.
General Command Syntax
ESC [ Pn SP C
Decimal: 27 91
Pn
32 77
Hex: 1B 5B
Pn
20 43
BASIC: CHR$(27);”[“;
Pn
;” C”;
S7C1T Select 7-Bit C1 Transmission:
This sequence causes the printer to
use 7-bit encoding for all C1 control characters transmitted. All C1
characters are then represented as two-character ESC sequences.
General Command Syntax
ESC SP F
Decimal: 27 32 70
Hex: 1B 20 46
BASIC: CHR$(27);” F”;
NOTE
Pn1 is a decimal value that specifies the height of the font as a
percentage of the height set by the GSS sequence. Pn2 is a
decimal value that specifies the width as a percentage of the
width set by the GSS sequence. Fonts can be modified by two or
three times their default height and two times their default
width.
NOTE
Pn is a decimal value that species the height of the font in
units determined by the Select Size Unit (SUU) sequence. The
width of the font is implicitly defined by the height. The
default value for Pn is 100. The GSS sequence remains in effect
until the printer receives another GSS sequence or a Graphic
Size Modification (GSM) sequence.