Filter
Top Products
GEK-00029B 5000 Series Programmer’s Manual
15
FF Form Feed (0CH):
Line terminator. The paper is advanced to the
next
top-of-form position. When the EVFU is enabled and programmed, paper
will advance to the next stop in channel 1.
HT Horizontal Tab (09H):
Advances the print position to the next
horizontal tab location. If no tabs are set, an HT code is either converted to a
space or ignored, depending on the menu option settings.
LF Line Feed (0AH):
Line terminator. The paper is advanced to the
next
line. When printing horizontal dot graphics, the paper is advanced to the next
dot row.
SI Shift In (0FH):
Used to exit a Special Print Mode (GENSPM) when
ANSI emulation strap 1 (Appendix G, tables 5 and 6) is active.
SO Shift Out (0EH):
Used to enable a special print mode (GENSPM)
when
ANSI emulation strap (Appendix G, tables 5 and 6) 1 is inactive.
VT Vertical Tab (0BH):
Line terminator. The paper is advanced to
the
next vertical tab stop. If no tabs are set, a VT code causes a line feed. When
using the EVFU, paper advances to the next stop in channel 12.
NOTE
An option strap from the CCU Control Panel Menu using the
SETUP/FORMAT/MODIFY FORMAT/GENPRTOPTS selection
can disable this feature.
(See note for <FF>, above.)
(See note for <FF>, above.)