Filter
Top Products
Chapter 2. ANSI Emulation GEK-00029B
34
ESC [ p1; ... pn h SM (Set Mode):
Sets the mode or modes specified by the parameters
listed below. Parameters preceded by the 'greater than' sign are
privately defined modes and should be sent separately.
Parameter
Number
Mode
Mnemonic Mode Function
20 LNM Line Feed New Line Mode
LNM - Line Feed New Line Mode
. When using this mode, a received
line feed command causes a carriage return (new line). When LNM is
reset, a line feed command only causes a vertical position movement.
The following parameters are privately defined modes.
Parameter
Number
Mode
Mnemonic
Mode Function
>1 GENPRM Proportional Print Mode
>2 GENC1C C1 Control Code Mode
>5 GENCS2 Character Set 2 Mode
GENPRM (Proportional Print Mode):
Enables proportional printing.
This mode does not apply to the oversize character feature. When
reset (default), characters are spaced at the current cpi.
GENC1C (C1 Control Code Mode - PC Set 1):
When set, it allows
the use of C1 control codes. When reset, 80H - 9FH are ignored. See
Appendix E for an explanation of how character sets are mapped. The
default state is set using ANSI emulation option 6 (see Appendix D,
ANSI (4800) or ANSI (4410) Tables).
GENSC2 (Character Set 2 Mode - PC Set 2):
Selects character set 2
of any of the 8-bit international character sets. See PC Set 2 in
Appendix H for an explanation of how character sets are mapped. The
default state is set using option strap 7 in the ANSI emulation
options (see Appendix D, ANSI (4800) or ANSI (4410) Tables).
EXAMPLE: To print proportional, send ESC [ > 1 h.
Decimal: 27 91 62 49 104
Hex: 1B 5B 3E 31 68
BASIC: CHR$(27);"[>1h";
ESC [ p1 ... pn l RM (Reset Mode):
Resets any modes turned on by the Set Mode
command above. Parameters and syntax are the same.