Filter
Top Products
ENWW 175
Media in another input tray is the same
size as the transparencies, and the printer
is defaulting to the other tray.
Make sure that the input tray containing the
transparencies or glossy paper is selected in
the software application or printer driver. Use
the printer control panel to configure the tray to
the media type loaded.
The tray containing the transparencies or
glossy paper is not configured correctly for
type.
Make sure that the input tray containing the
transparencies or glossy paper is selected in
the software application or printer driver. Use
the printer control panel to configure the tray to
the media type loaded. See Configuring input
trays.
Transparencies or glossy paper will not feed
Envelopes jam or will not feed in the printer
Cause Solution
Envelopes are loaded in an unsupported
tray. Only Tray 1 can feed envelopes.
Load envelopes into Tray 1.
Envelopes are curled or damaged. Try using different envelopes. Store envelopes
in a controlled environment.
Envelopes are sealing because the moisture
content is too high.
Try using different envelopes. Store envelopes
in a controlled environment.
Envelope orientation is incorrect. Verify that the envelope is loaded correctly.
See Configuring input trays
.
This printer does not support the envelopes
being used.
See Supported media weights and sizes
or the
HP LaserJet Printer Family Paper
Specification Guide.
Tray 1 is configured for a size other than
envelopes.
Configure Tray 1 size for envelopes.
Output is curled or wrinkled
Cause Solution
Media does not meet the specifications
for this printer.
Use only media that meets the HP media
specifications for this printer. See Supported
media weights and sizes.
Media is damaged or in poor condition. Remove media from the input tray and load
media that is in good condition.
Printer is operating in an excessively humid
environment.
Verify that the printing environment is within
humidity specifications. See Printer
specifications.