Filter
Top Products
ENWW 37
5. Press ✔ to select SYSTEM SETUP.
6. Press to highlight CLEARABLE WARNINGS.
7. Press ✔ to select CLEARABLE WARNINGS.
8. Press or to select the appropriate setting.
9. Press ✔ to set the selection.
10. Press P
AUSE/RESUME.
Auto continue
You can determine printer behavior when the system generates an
Auto Continuable error. ON is the default setting.
z ON displays an error message for ten seconds before
automatically continuing to print.
z OFF pauses printing any time the printer displays an error
message and until you press ✔.
To set the auto continue
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press ✔ to select SYSTEM SETUP.
6. Press to highlight AUTO CONTINUE.
7. Press ✔ to select AUTO CONTINUE.
8. Press or to select the appropriate setting.
9. Press ✔ to set the selection.
10. Press P
AUSE/RESUME.
Supplies low
The printer allows two options for reporting that supplies are low;
CONTINUE is the default value.
z CONTINUE allows the printer to continue printing while displaying a
warning until the supply is replaced.
z STOP causes the printer to pause printing until you replace the
used supply or press ✔, which allows the printer to print while
continuing to display the warning.