Filter
Top Products
32 ENWW
Changing printer control panel configuration
settings
By using the printer control panel, you can make changes to general
printer configuration default settings such as tray size and type,
PowerSave time, printer personality (language), and jam recovery.
The printer control panel can also be accessed from a computer by
using the setting page of the embedded Web server. The computer
shows the same information that the control panel shows. For more
information, see Using the embedded Web server
.
CAUTION Configuration settings seldom need to be changed. Hewlett-Packard
recommends that only the system administrator change configuration
settings.
Job storage limit
This option sets the limit for the maximum number of jobs stored on
the hard disk at the printer. The maximum number allowed is 100, and
the default value is 32.
Note This option is only available if a hard disk is installed.
To set the job storage limit
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight SYSTEM SETUP.
5. Press ✔ to select SYSTEM SETUP.
6. Press ✔ to select JOB STORAGE LIMIT.
7. Press or to change the value.
8. Press ✔ to set the value.
9. Press P
AUSE/RESUME.