Filter
Top Products
48 ENWW
To configure the Novell NetWare parameters from the
printer control panel
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press ✔ to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press to highlight NOVELL.
9. Press ✔ to select NOVELL.
10. Press to highlight FRAME.
11. Press ✔ to select FRAME.
12. Press the P
AUSE/RESUME button to return to the ready state.
Note The default frame type value for the HP Color LaserJet 4600 is
automatic.
Configuring TCP/IP parameters
You can use the printer control panel to configure the following
TCP/IP parameters:
z usage of the BOOTP file for configuration parameters (the default
is to use the BOOTP file)
z IP address (4 bytes)
z subnet mask (4 bytes)
z default gateway (4 bytes)
z TCP/IP connection timeout (in seconds)
Note Do not disable BOOTP if you will be using RARP or DHCP to
configureTCP/IP parameters.
To automatically configure TCP/IP parameters from
the printer control panel
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.