Filter
Top Products
50 ENWW
Setting the subnet mask
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press ✔ to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press to highlight MANUAL.
9. Press ✔ to select MANUAL.
10. Press to highlight SUBNET MASK.
11. Press ✔ to select SUBNET MASK.
Note The first of three sets of numbers is highlighted. If there is not a number
highlighted, a highlighted empty underscore appears.
12. Press the or arrow to to increase or decrease the number
for configuring the subnet mask.
13. Press ✔ to move to the next set of numbers.
14. Repeat steps 12 and 13 until the correct subnet mask is entered.
15. Press the P
AUSE/RESUME button to return to the READY state.
Setting the local and default gateway
1. Press ✔ to enter the MENUS.
2. Press to highlight CONFIGURE DEVICE.
3. Press ✔ to select CONFIGURE DEVICE.
4. Press to highlight I/O.
5. Press ✔ to select I/O.
6. Press to highlight EIO X (where X = 1, 2, or 3).
7. Press ✔ to select EIO X.
8. Press to highlight MANUAL.
9. Press ✔ to select MANUAL.
10. Press to highlight LOCAL GATEWAY or DEFAULT GATEWAY.
11. Press ✔ to select LOCAL GATEWAY or DEFAULT GATEWAY.