Filter
Top Products
Configuration Menu
The items on the Configuration Menu set default parameters for
two-sided printing, binding, selected output bin, printing personality,
auto continue, power saving, resource saving, page protection and the
display of maintenance messages when the toner supply is low or
service is needed. Table 4-9 presents the messages that appear when you
select each of these menu items.
Table 4-9 Configuration Menu
Menu Item Explanation
CONFIGURATION MENU
SERVICE MESSAGE=
[ON,OFF]
Appears at approximately 350,000-image intervals,
when the PERFORM USER MAINTENANCE message
appears.
2-SIDED=
[OFF*,ON]
Allows selection of duplex (two-sided) printing as
the default printing mode (only appears if the
optional Duplex Unit is installed.)
BINDING=
[LONG EDGE*,
SHORT EDGE]
Allows control of the binding edges of duplexed
documents (only appears if the optional Duplex
Unit is installed.) More information about binding
options is located in Chapter 5, “Print Tasks.”
PAPER DESTINATION=
[TOP OUTPUT BIN*,
LEFT OUTPUT BIN,
OPTIONAL OUTBIN]
Allows the selection of the default output bin. More
information about the output bins is located in
Chapter 5.
When an output bin is full of paper, printing is
stopped and one of the following messages is
displayed: REMOVE PAPER FROM TOP OUTPUT BIN or
REMOVE PAPER FROM OPTIONAL OUTBIN n. Empty
the bin to resume printing.
(Note that the Left Output Bin will not cause the bin
full message to be displayed.)
By selecting the Stapler (if installed) as the output
bin, you can have your documents stapled.
ORIENTATION=
[PORTRAIT*,
LANDSCAPE]
Sets the default orientation of the printed page. The
orientation setting in your software application
overrides the control panel setting.
POWER SAVE DELAY=
[1 HR*
2 HRS
3 HRS
OFF
15 MINUTES
30 MINUTES]
Allows you to change the setting for the time
interval the printer remains inactive prior to
entering Power Save mode. Warm up time for the
printer after the power save delay is approximately
60 seconds.
* Factory default.
Continued on the next page
4-24 Printer Control Panel EN