Filter
Top Products
Table 4-9 Configuration Menu,
continued
Menu Item Explanation
CONFIGURATION MENU
PERSONALITY=
[AUTO*,PCL,
POSTSCRIPT]
Controls selection of the printer personality. The
choices available depend on which personalities
are installed. AUTO is the default, and allows the
printer to automatically determine the personality
needed for a given job.
AUTO CONTINUE=
[ON*,OFF]
Allows the printer to resume printing after
noncritical errors occur. If ON is selected, the
printer goes offline and the error message is
displayed for ten seconds. After ten seconds, the
printer automatically returns to online. If turned off,
the printer will remain offline until attended.
RESOURCE SAVE=
[AUTO*,OFF,ON]
Sets resource saving to ON, OFF, or AUTO (which
automatically determines how much memory to
use for each installed personality). When set to ON,
you can select a specific amount of memory for
resource saving.
PCL MEM=nnnnnK
or
POSTSCRIPT MEM=
nnnnnK
This item becomes visible only if Resource Save is
set to ON. The value nnnnnK indicates the number
of KBytes of memory reserved for that personality.
The choices for this item range from 0 to the total
amount of available memory in the printer in
100-KByte increments. Press [+] repeatedly to
increase reserved memory.
TONER LOW=
[STOP*,CONTINUE]
This item controls the printer action taken when low
toner levels are detected. By default, the printer will
stop. (As toner runs low, the quality of the printed
page will deteriorate.)
PAGE PROTECT=
[ON,AUTO*]
PAGE PROTECT appears after a 21 PRINT OVERRUN
error has occurred. Try to simplify the format of the
job. If you must print the job “as is,” set PAGE
PROTECT to ON, then later return it to AUTO. Do not
leave PAGE PROTECT set to ON as it will degrade
performance.
* Factory default.
4
Printer Control
Panel
EN Printer Control Panel 4-25