Filter
Top Products
Printing to the Multibin Mailbox or Mailbox
with Stapler
The optional Multi-Bin Mailbox or Mailbox with Stapler can work in
one of three modes: mailbox mode, job separation mode, or stacking
mode. The network or printer administrator determines which mode of
operation is chosen through an HP network configuration utility, such as
HP JetAdmin or HP LaserJet Utility. You need to set up your printer
driver to reflect the mode chosen by the administrator. Bidirectional
environments automatically reflect the administrator’s choices in your
printer driver.
The printer control panel displays different names for the mailboxes and
stapler, depending on which mode the driver is using.
In Mailbox Mode, if the
Control Panel says:
Then the physical
location is:
OPTIONAL OUTPUT BIN 1
Left Output Bin
OPTIONAL OUTPUT BIN
2
through 6
Mailbox 1-5
OPTIONAL OUTPUT BIN X
Stapler Bin
(X represents any number other than 1 through 6.)
In Job Separation or
Stacking Modes, if the
Control Panel says:
Then the physical
location is:
OPTIONAL OUTPUT BIN 1
Top Output Bin
OPTIONAL OUTPUT BIN 2
Mailbox bins
OPTIONAL OUTPUT BIN X
Stapler Bin
(X represents any number other than 1 through 6.)
Selecting the Multi-Bin Mailbox or Mailbox with Stapler
through the Software
You can select these output bins through your software application,
printer driver, or from the printer control panel. It is better to designate
the paper destination in your software or printer driver since you will
control to which output bin your job is sent. Otherwise, follow the
instructions below for setting the overall default output bin selection.
Note Where and how you make selections depends on your software
application or associated printer driver. The selection process may be
available only from within the printer driver. See Chapter 3 or your
application manual for more information.
5
Print Tasks
EN Print Tasks 5-27