Filter
Top Products
PPP
LCS60 Configuration and Connection for PPP Service
Note: If your client package does not support entry of a zero IP address (i.e., it
is not fully IPCP/PPP conformant) enter the reserved IP address instead
of zero.
If you are using a reserved address but not authenticating by means of a
NAC, then you must also specify your userid on the data switch dial-
string as shown below:
DESTINATION:
area/exch/60name.ppp..-uuserid
This specifies the full address of your LCS60 including the userid entered when
the address was reserved. For example, for a userid hartnell on the LCS60 morse:
DESTINATION: mlkway/earth/morse.ppp..-uhartnell
Note: When reserving IP addresses, it may take as much as a minute for the IP
Network Address Server to detect changes in the database. Users who
attempt to log on before that delay will not receive their reserved IP
address.
Dynamically Assigned IP Address
The LCS60 will assign an IP address dynamically from the IP network range
associated with the called IP Network Security Group. To do so, the session start
up request must meet one of the following conditions:
The user has included the -D option on his/her data switch dialstring and
has a negotiable IP address administered in his/her client software pack-
age.
The -D option has been omitted from the dialstring and the user does not
have a reserved IP address administered in the LCS60 configuration data-
base.
To obtain a dynamic address from the LCS60 for your Mac or PC you must:
Issue 3 4-17