Filter
Top Products
LCS60 Software
Configure Protocols and Gateway Services — srvsetup
Top>Config># srvset
LCS60 Protocols and Services Configuration Procedure
The "srvsetup" procedure leads you through the steps to configure the LCS60
protocols and services. Before you run "srvsetup", you should read about LCS60
configuration in the "LCS60 Network Interface Installation and Administration
Guide" and assemble the information required for configuration.
[ q to quit, RETURN to continue ]
==> Return
*** This step allows the LCS60 Administrator to define which services will
*** be activated on this LCS60 whenever the system is rebooted.
PROTOCOL/SERVICES TO BE STARTED WHEN BOOTING
1 Add Protocol/Service to Configuration
2 Delete Protocol/Service from Configuration
3 Display Current Protocol/Service Configuration
Enter Menu Selection
[? for help, q to quit, RETURN for menu]
==> 1
Please choose from the following protocols/services
that you want to add:
**> arap asytcp atalk ipx ppp routed slip snmp tcpasy tcpip <**
Enter the protocol/service name(s) to be added
[? for help, q for MENU]
==> atalk ipx tcpip slip ppp arap asytcp tcpasy routed
"atalk" is added!
"ipx" is added!
"tcpip" is added!
"slip" is added!
"ppp" is added!
"arap" is added!
"asytcp" is added!
"tcpasy" is added!
"routed" is added!
PROTOCOL/SERVICES TO BE STARTED WHEN BOOTING
1 Add Protocol/Service to Configuration
2 Delete Protocol/Service from Configuration
3 Display Current Protocol/Service Configuration
Issue 3 3-11