Filter
Top Products
StarKeeper II NMS
Configuration of the StarKeeper II NMS
# cd /tmp
# mt rew
# cpio -ivdumB < /dev/rmt/0mn
# ./UNINSTALL
c . Enter i Return when you see the following:
Connections for L60 must either be removed or made inactive.
If you are upgrading L60 you should make the connections inactive,
otherwise connection information will have to be re-entered.
Enter "r" to remove, or "i" to make inactive: i
d . Remove the diskette or tape from the drive.
5 . Enter the package installation command and follow the instructions:
For 6386
Hardware
Enter /usr/bin/installpkg; then enter F to install the
floppy diskette. Insert the floppy diskette labeled LCS60
Network Interface for Ethernet R3.0 StarKeeper® NMS RX.Y
Support for AT&T 6386 into the disk drive when instructed
to do so.
For HP
Hardware
Insert the tape labeled LCS60 Network Interface for Ethernet
R3.0 StarKeeper® NMS RX.Y Support for Hewlett-Packard
into the tape drive and wait until the light stops blinking.
Then execute the following four commands:
# cd /tmp
# mt rew
# cpio -ivdumB < /dev/rmt/0mn
# ./INSTALL
Issue 3 B-3