Filter
Top Products
StarKeeper II NMS
Configuration of the StarKeeper II NMS
6 . Remove the floppy diskette or tape from the drive when installation is
complete.
7 . Enter exit Return to restore the user id to cnmsadm.
8 . Re-start the StarKeeper II NMS:
a . At the SK: prompt, enter SKsh; this displays the main menu
b . Choose SYSADM ; this displays the sysadm menu
c . Choose STARTSK; select y to continue with startup. Enter
Return when you see the startup completed message.
d . Exit the SKsh program by pressing Return and then y at the
Exit the Menu Program? prompt.
9 . You can now configure the database to monitor individual LCS60s (see
below).
StarKeeper II NMS – Configuration Commands
After the software package has been installed, the network administrator can
configure the StarKeeper II NMS’s database to monitor individual LCS60s.
1 . Log on to StarKeeper II NMS as cnmsadm.
2 . At the SK: prompt, enter SKsh Return . This displays the selection
menu. Select the "Configuration Commands" by entering c Return ; this
displays the Network Elements menu.
3 . Select menu item System/Node by pressing Return . This displays the
"Configure a System/Node" menu.
4 . Select menu item Add by pressing Return .
5 . At System/Node name enter the name of the LCS60 (e.g., morse Return , in
the example in Figure 3-1).
6 . At Type enter L60 Return .
7 . At Release enter 3.0 Return .
B-4 Issue 3