Filter
Top Products
StarKeeper II NMS
Configuration of the StarKeeper II NMS
The LCS60 for Ethernet is compatible with the StarKeeper II NMS Releases 3.0
through 8.0 on the HP 720/730 platform and Release 3.0 and 4.2 on the 6386 plat-
form.
Note: To verify the version of StarKeeper II NMS that you are running, log on
to the StarKeeper II NMS as cnmsadm. To verify the version, the output
of help version should contain the following line:
StarKeeper (R) II NMS R
X.Y
where X.Y is the Release number.
Before the network administrator can use StarKeeper II NMS configuration com-
mands to configure the StarKeeper II NMS’s database to allow it to monitor indi-
vidual LCS60s, a software package must be installed on the StarKeeper II NMS
from a tape or floppy diskette.
After installing the software package and configuring the database, all standard
StarKeeper II NMS alarm features will be available for LCS60 alarms. This
includes all StarKeeper II NMS commands and utilities that access the alarm
database, and all dynamic and graphic displays of alarms.
The procedures for installing the software package and then configuring the
database depend on the specific release of the StarKeeper II NMS. Follow the
appropriate procedures that follow.
Note: If you are upgrading an LCS50 to an LCS60, you must first delete the
LCS50-NIK entry on the StarKeeper II NMS and re-enter the database
record for the LCS60.
Diskette or Tape Installation
To install the software package:
1 . Log on to the StarKeeper II NMS console as cnmsadm.
2 . Stop the StarKeeper II NMS; installation will abort if it is running
a . At the SK: prompt, enter SKsh; this displays the main menu
Issue 3 B-1