Filter
Top Products
Error Messages
Outgoing Call Error Messages
Dkserver: Can’t set/get circuit parameters: Call System Administrator.
The call could not be accepted because the dkserver process could not
communicate with the host device. Either the incoming initialization or
buffer size could not be set or the the receiving buffer size could not be
returned in the answer.
You may also see this error message on an incoming call from a DESTINA-
TION prompt displayed as error code 135.
Dkserver: Call on a busy device or call collision, try again.
The call could not be accepted because the host device is busy or because
the incoming call collided with an outgoing call. A busy device is one that
is being cleaned up from a prior call or a device that is held open by some
lingering process.
You may also see this error message on an incoming call from a DESTINA-
TION prompt displayed as error code 136.
Endpoint hung up
The endpoint hung up the call. This is not an error.
Facility not subscribed
The facility on the SIM was not subscribed to.
Hop count exceeded
The call could not be completed because the hop count configured for this
node was exceeded.
Host configuration mismatch. Call Network Administrator
The call was rejected because the host channel picked for the outgoing call
is not configured on the network. Contact the data switch Network
Administrator.
Host protocol error
The call could not be completed because of an error detected in the host
protocol.
Issue 3 C-5