Filter
Top Products
ARAP
LCS60 Configuration and Connection for
ARAP Service
Figure 6-1 shows an example network using ARAP service.
Note: ARAP service requires an R2.0 or R3.0 software key. Refer to Chapter 3
for information about the software key.
Figure 6-1: Example Network – ARAP Service
Lucent Data Switch
LCS60
Router
AT&T
LCS200
Modem Pool
Remote Access Clients
LAN
You can configure the LCS60 for ARAP service using either the srvsetup
command or the individual commands (protocol, maxsessions, atalkas). The
examples in this chapter use the individual commands.
If previous configuration (for example, for PPP service) has been performed,
some of the steps required for configuring the LCS60 for ARAP service may have
already been completed (e.g., atalkas). Skip the steps that have been completed
previously.
Note: The user should familiarize him/herself with all aspects of the LCS60
ARAP and AppleTalk service. Refer to Chapter 1.
After configuring the LCS60 as described under Initial Setup in Chapter 3, per-
form the steps shown in Figure 6-2 to configure the LCS60 ARAP Service.
Issue 3 6-1